CL3512ACL3512ACL3512ACL3512ACL3512ADigital Thermometer & CalibratorDigital Thermometer & CalibratorDigital Thermometer & CalibratorDigital
72.4 Source Mode Procedure (Calibration Simulation)1. Turn CL3512A on by turning selector switch to any one of the outputselector positions.2. Press T
Source Mode Diagram8
93.0 Operator MaintenanceWARNINGTo avoid possible electrical shock, disconnect the thermocoupleconnectors from the thermometer before removing the cov
104.0 SpecificationsELECTRICALTemperature Scale: Celsius or Fahrenheit user-selectableMeasurement Range:Thermocouple RangeK-TYPE(0.1°C) -200°C to 13
GENERALDisplay: 3½ digit liquid crystal display (LCD) with a maximum reading of1999.Polarity: Automatic,positive implied,negative polarity indication.
5.0 CL3152A Calibration ProcedureNote: The following calibration procedure should be performed only byqualified technicians who have access to the ite
13"Simulated Output" Test1. Turn the knob "COARSE" right to the end, knob of RANGE turn right tothe last two position, press "
1CL3512A CALIBRATION PROCEDURESNote: The following calibration procedure should perform only by qualified technicianswho have access to the items as f
WARRANTY / DISCLAIMEROMEGA ENGINEERING, INC. warrants this unit to be free of defects in materials and workmanship for a period of 13 monthsfrom date
Where Do I Find Everything I Need forProcess Measurement and Control?OMEGA...Of Course!TEMPERATURE" Thermocouple, RTD & ThermistorProbes, Con
OMEGAnetSM On-Line Servicehttp://www.omega.comInternet [email protected] North America:USA: ISO 9001 Certified Canada:One Omega Drive, Box
Table of contents1.0 Introduction1.1 Safety Information1.2 Unpacking2.0 Operation Procedure2.1 Unit Drawing2.2 Description of Buttons and Switches2.3
11.0 IntroductionThe OMEGA® CL3512A calibrator/thermometer is two meters in one. TheCL3512A simulates type J/K/T/E thermocouple signals. Each signal i
21.2 UnpackingRemove the packing list and verify that all equipment has been received. Ifthere are any questions about the shipment, please call the O
2.0 Operation Proceedure2.1 Drawing of Unit3Actual Dimensions: 195mm(H) x 92mm(W) x 53mm(D)
42.2 Descriptions of Buttons and Switches/ ButtonsTemperature is displayed in either degrees Celsius(°C) or degreesFahrenheit(°F). When the thermomet
5/ / Input SelectionsThe input selection indicates which input is selected; T1 thermocouple, T2thermocouple or the difference between the two thermoc
62.3 Read Mode Proceedure1. Plug Thermocouple Sensor into input T1 and/or T2.2. Turn selector switch to Input.3. Select proper thermocouple type (J, K
Komentáře k této Příručce