Omega-vehicle-security Wireless Sensor System zSeries Uživatelský manuál stáhnout pdf (Strana 11)

PART 2 HARDWARE

2.1a Parts of the End Device (zED-P/-LCD/-AA)

1 8 position DIP switch (under cover), sets the NID and DID of the End Device

(see Section 2.7 for details)

2 Power Switch

3 Label for Unit Address, Group No. and Network ID Address (NID)

4 Wall mounting holes

5 Label with model and serial numbers

6 Radio module firmware revision location on label

7 Case’s tray, where the PCB, sensor and batteries are mounted

8 Case’s cover

9 Transmit LED (blue)

10 4 Screws attaching Cover

11 External probe/sensor, through cable gland (for zED-TC-x) or quick

disconnect connector . Refer to Figure 2.2a for connector configurations.

12 Power Input, through quick disconnect connector (for zED-P & zED-LCD)

13 Antenna Mount

14 Thermocouple (if ordered) removable terminal block connector (under cover)

15 LCD Display (for zED-LCD & zED-LCD-AA)

16 Two AA alkaline batteries (for zED-LCD-AA) or one lithium back-up battery

(for zED-P & zED-LCD) (located under cover)

Figure 2.1a Parts of the End Device (zED-P/-LCD/-AA)

POWER

INPUT

5 VDC

SENSOR

INPUT

MODEL #

SERIAL #

#.#

Unit Addr Group Net. Addr

FRONT

REAR

1314

Warning:

the following parts are

ESD sensitive.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 91 92

Žádné komentáře

Omega-vehicle-security Wireless Sensor System zSeries Uživatelský manuál Strana 11